Hello,
I am trying to Beaglebone to work with Yoctoproject. I followed the
instructions from
https://www.yoctoproject.org/downloads/bsps/jethro20/beaglebone and copied
sato-image to SD card. But the image won't boot.
*A Note on how I partitioned my SD:*
sudo fdisk -lu /dev/sdb
Disk /dev/sdb: 15.5 GB, 15523119104 bytes
64 heads, 32 sectors/track, 14804 cylinders, total 30318592 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x000d842d
Device Boot Start End Blocks Id System
/dev/sdb1 * 2048 67583 32768 c W95 FAT32 (LBA)
/dev/sdb2 67584 30318591 15125504 83 Linux
I'm using PL2303 USB-TTL cable to debug.
*O/P on the serial console* :
U-Boot SPL 2016.01 (Feb 15 2016 - 19:53:09)
Trying to boot from MMC
reading args
spl_load_image_fat_os: error reading image args, err - -1
reading u-boot.img
reading u-boot.img
U-Boot 2016.01 (Feb 15 2016 - 19:53:09 -0500)
Watchdog enabled
I2C: ready
DRAM: 512 MiB
NAND: 0 MiB
MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1
*** Error - No Valid Environment Area found
*** Warning - bad CRC, using default environment
Net: <ethaddr> not set. Validating first E-fuse MAC
cpsw, usb_ether
=>
The problem is not with my board/SD card. I tried on a different set..same
error pops.
Can some one please help me debug this? what are the possible reasons for
'Error
- No Valid Environment Area found'?
Thank you
Phani
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
