>> After some reading of the kernel sources (always a pleasure), I've found >> how to enable 2x2 MIMO on the BBGW. I'm getting 77Mbit/s downstream (TCP >> iperf), which is pretty cool, but only 22Mbit/s upstream.
> Is this AP/sta or adhoc mode? Client mode to a WNDR 3700 situated in the next room. I didn't run any more extensive tests, I was only trying to ensure that MIMO was functional. (If you asked me, I'd guess that the AP is doing aggregation and the STA isn't, but since you aren't asking, I'm not going to guess.) > It may be you are running low on memory bandwidth or cpu. Perhaps. > I'd done a test over usbnet to the board and got about the same result. For me, usbnet goes the other way around (upstream traffic has higher throughput than downstream). It would probably take a USB protocol analyser to understand why. > Does the wifi use the softmac layer? It looks to me like a completely separate module implemented in its own microcontroller (I think it's connected through SDIO, plus a UART, plus a GPIO, plus an interrupt line). Jason, do you know where I can find the programming manual? -- Juliusz -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/87twfa13ja.wl-jch%40pps.univ-paris-diderot.fr. For more options, visit https://groups.google.com/d/optout.
