<https://lh3.googleusercontent.com/-8-nBsj4ihVI/V583Tc6x17I/AAAAAAAAnqM/Ha2M2d1kmIUp3M0F73IJeYVPcW5q89YAwCLcB/s1600/RIGOL%2BPrint%2BScreen1-08-2016%2B3_29_33%2BPM.835.bmp> Our test lab graciously retested (just for positive peeks - not quasi peeks ) with the device outside the housing. You are correct some of the peeks where a few dB worse outside the housing although overall the system still failed. The 250MHz and 1000Mz did disappear when the shielded Ethernet cable was used too.
At this stage I'm looking at moving to a beagle bone green. My rough pre compliance test with a H probe ~ 14mm above the board had the following results -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/127f2586-2f4e-4358-a124-75ac7f9b3349%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
