Is the power LED on? Gerald
On Wed, Dec 14, 2016 at 8:27 PM, <[email protected]> wrote: > While attempting to connect an SiK telemetry radio (the old 3dr) I became > aware that I do not have any voltage reading on the SYS_5V pin. I've check > both, number 8 and 9 and the same issue. On the VDD_3V3 and VDD_5V pins I > only have 1.5 volts. I've read through the documentation and it states that > SYS_5V should have a voltage reading, even when using a USB cable. I should > have plenty of juice, i'm using a 5V-5A power supply. > > What could be causing this? I have not seen anything saying the pins need > to be "activated" or something like that. Otherwise the board seems to be > working fine, I have no boot up issues and have even used the BBB to > command a RoboClaw motor controller successfully. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit https://groups.google.com/d/ > msgid/beagleboard/d640f7ae-87f2-4e80-b952-738636b40436%40googlegroups.com > <https://groups.google.com/d/msgid/beagleboard/d640f7ae-87f2-4e80-b952-738636b40436%40googlegroups.com?utm_medium=email&utm_source=footer> > . > For more options, visit https://groups.google.com/d/optout. > -- Gerald [email protected] http://beagleboard.org/ [email protected] -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAHK_S%2BcaiJiWR%2Bgwe7B8sjiM3%2BHewLJH0wmEYrJ%3DhaixzP3ONQ%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
