On Sun, Nov 18, 2018 at 8:11 PM Prakash Dash <danpurprak...@gmail.com> wrote: > > Hi Robert, > > Will it be fine if i routed INT1 or INT2 to one of the GPIO pin of the P-9 or > P-8 header. > > If i will do this before that i have to mux that GPIO pin for input mode. > and same pin info i have to configure in device tree under adxl345 node as > mentioned below. > as > > interrupt-parent = <&gpio> > interrupts = <gpio pin no> > > could you please suggest whether this is the correct procedure or not what I > asked above. > could you please suggest the procedure for mapping the INT1 or INT2 pin to > any of the > pin header(P-9 or P-8) of the beaglebone black board.
You can map it to any un-used pin, as long as you specifiy it.. > > Please kindly help me on this. > Without this configuration i can not able to collect the X,Y,Z axis data. That's incorrect, you can always "poll" the data.. It's not IRQ driven, so it's not as efficient.. Regards, -- Robert Nelson https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAOCHtYid2Aa4tA4SdyRxsG-GTbFw0_2Qycu21noRzeE8UMjD%2BA%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
