i posted this on element14 as well as the Google forum and thought I might have some luck here.
So, I loaded the latest Debian image for the Beaglebone boards, Debian 9.5 2018-10-07 4GB SD LXQT, and was using this for a short bit, but for some reason after trying to run a QT compiled program via remote ssh, the BBBlue froze and will not boot any more. I powered off the board and when it powers on only the Green and Red LEDS from the status bank stay constantly on and the Battery LEDs flash a bit but then 2 stay on constantly; CHG and the one labeled 75. I have removed all of the EduMIP connections from the board as well as a n LCD that was connected but still nothing happens. This board does not have the FTDI connections like the Black so I do not have a way to get a console to it to see if it is locking up somewhere. I've tried removing the uSD card as well as use a known good one but still no luck. This board was running fine for sometime now so I am not sure what happened. It was not until I loaded the new image that I ran into an issue. NOTE: I did do a 'apt-get install dist-upgrade' which put the Debian version at 9.6 so I am not sure if that caused an issue but I can not see it causing a bricked board. Anyone else run into this issue with the Blue? Cheers, Jon -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/d9f42479-f426-49fe-be27-aa601d20f2bd%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
