Still working on getting a PocketBeagle(ish) board fully up.
This board is using an ST1633 touch screen and I need a very current kernel
to support that.
So I jumped to v5.1-r3c-bone0 using the bb-kernel git repository to cross
build.
I am having some minor problems with that as more than half the time
./build_deb.sh fails compiling the kernel.
But I can usually just run it again and most of the time it succeeds.
I am using a USB dm9601 ethernet NIC to connect to the board for
debugging.
This is working fine with the 4.18.20-bone16 kernel.
But when I install the linux kernel deb for 5.1-rc3 the DM9601 is detected
late in the boot, it is named eth0.
Ifconfig lists it as expected but it did not dhcp an address.
I can use
MAC=00e04c534458
connmanctl config ethernet_${MAC}_cable --ipv4 dhcp
to get it to dhcp an address,
but the change is not persistent accross boots and the connection does not
stay up very long before dropping.
I can go to /boot/uEnv.txt and set
uname_r=4.18.20-bone16
reboot and everything works fine.
I have tired to look for linux .config file differences between 4.18.20 and
5.1-rc3 - there are alot of them.
I beleive I have picked up any that might have anything to do with this.
But still not joy.
Any Ideas on something else I can try ?
--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups
"BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/beagleboard/dd6ad76f-8999-48e2-b7e7-af4b8bc812e2%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
