On Mon, May 20, 2019 at 6:58 AM Fred Kerr <[email protected]> wrote: > Hello! > > This has been my back-burner project since I started looking at Pocket > Beagle. I'll get back to it soon. I got a thermistor a while ago and will > get a test bed set up again, finally, again. > > It's my understanding the thermistor is required for charging and you can > just use a 10k resistor for simple discharge use. >
The thermistor isn't required, just a safety measure. Care around LiPo batteries should always be considered. > > I need to verify this and check on the firmware side of things. Back when > I started with Pocket Beagle, fw update was needed to support charging. > I've been doing charging with the latest images that seem to have it enabled. I'll try to put a GamePup on a scope the next few days to see that it is doing, but the battery gets charged. > > Regards, > Fred > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/3d960a88-9c65-4751-995c-9914b3c2d623%40googlegroups.com > . > For more options, visit https://groups.google.com/d/optout. > -- https://beagleboard.org/about - a 501c3 non-profit educating around open hardware computing -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CA%2BT6QPmUiTHchvdBUrUFgxzra_fu_nEhzyijbu3FRd6-2gQ4-A%40mail.gmail.com. For more options, visit https://groups.google.com/d/optout.
