Isn't that just a pull-up or pull-down resistor? My board has it too. https://github.com/beagleboard/beaglebone-ai/wiki/System-Reference-Manual#223-rev-a1a
Ted Roth On Sat, Sep 28, 2019 at 9:56 AM Dennis Lee Bieber <[email protected]> wrote: > On Sat, 28 Sep 2019 05:19:09 -0700 (PDT), in > gmane.comp.hardware.beagleboard.user Mike Brandon > <[email protected]> wrote: > > >@Paul - Would you be able to take a close up picture of the backside > >solder points of the serial debug connector (3 pin next to USB C)? > > > > Not "Paul" but... attached image I hope > > > >My AI was overheating too until it stopped booting all together. I was > >looking to monitor serial as I applied power and that is when I noticed > >what appeared to be an unclean solder point...its not shorted there is a > >99kOhm resistance between the two points. > > > > Similar... Do I take a needle file to it, or risk a soldering > gun... Or > complain to Newark about a defect... > > -- > Dennis L Bieber > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/ch0voeducvai6svmhn2nmleld0nf9di9ga%404ax.com > . > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAMyzTKGYW98LePdDGBYKdh8uYoVY11%3DwQP5m4eYy9wb7fFbtww%40mail.gmail.com.
