If you can on the SD-Card open /boot/uEnv.txt and show the LAST line.
If it starts with # then the eMMc is not being flashed To cause the eMMc to be written remove the # at the start of the line. After making that change leave the SD-Card in and re-boot the Beaglebone. If all is good the leds should start blinking back and fourth "Cylon from Battlestar G..." The unit should power off in about 10 minutes. Remove SD-Card. Re-boot and you should be running from eMMc. Keep in mind when cloning an image to adjust your IP address settings. You can't have duplicate IP addresses. Ken -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/768c2d8a-9712-4d74-81b8-6235c3d3ad59o%40googlegroups.com.
