Hello! I've just unboxed my beaglebone blue and followed the introduction to flash it. I downloaded the image AM3358 Debian 10.3 2020-04-06 4GB SD IoT <https://debian.beagleboard.org/images/bone-debian-10.3-iot-armhf-2020-04-06-4gb.img.xz>. I downloaded etcher and loaded the downloaded image onto an SD. It says it was successful. I plugged the SD into the BBBL, held down the SD button, and then plugged in the USB micro. The heartbeat LED does the pulse, and the 1, 2, and 3 status LEDs will flash randomly for a few seconds as well. Eventually it settles into the heartbeat flashing, with LED 2 flickering here and there with the occasional (once every ~5 seconds) LED 1 flash. I've left it and it's done this for over an hour and nothing has changed. I've read it's supposed to do the cylon-like sweep and only take ~10 minutes until all the LEDs turn off correct?
I'm using windows as well. I can connect to its wifi and go to 192.168.8.1 and it will register and tell me its connected, but I want to connect via serial. I've tried putty as well and it doesn't register the IP and times out. any ideas or anyone experience this before? I appreciate it. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/b12fe56e-1090-4a64-9279-a002c939d98co%40googlegroups.com.
