Yeah, this pops up from time to time so perhaps there is a way to make it sticky or something. Ex: https://groups.google.com/g/beagleboard/c/D0kLUD-zwHY/m/gqQW4FvBBAAJ
Or: https://forum.digikey.com/t/static-ip-on-beaglebone-black/4497 Cheers, Jon On Wed, Feb 3, 2021 at 9:08 AM Johan Ingvast <[email protected]> wrote: > I think I found the solution. > Debian for BB uses connman for handling eth0. > Found this that gives directions > https://variwiki.com/index.php?title=Static_IP_Address > > So what I had to do was > As root > Find the service name by > $ connmanctl services > It will output something like > *AR Wired ethernet_d05fb8efd72f_cable > The latter part will be used as reference to what to change > $ connmanctl config --ipv4 manual 192.168.10.156 255.255.255.0 > 192.168.10.1 > Where the order of the addresses are: ip netmask gateway > If you are on ethernet you will loose contact (in case the ip is changed), > connect again with the new address. > You also need to change the nameservers (better to do before) > $ connmanctl config --nameservers 8.8.8.8 4.4.4.4 > > > onsdag 3 februari 2021 kl. 17:12:29 UTC+1 skrev Johan Ingvast: > >> Hi >> I use Debian 10.3 on a beaglebone enhanced industrial and try to >> configure eth0 to a static ip. >> https://wiki.debian.org/NetworkConfiguration claim >> /etc/network/interfaces should have the lines >> auto eth0 >> iface eth0 inet static >> address 192.168.10.156 >> netmask 255.255.255.0 >> gateway 192.168.10.1 >> >> the commands ifup and ifdown should then take care of the switching. >> >> $ ifdown eth0 >> results in an error >> ifdown: interface eth0 not configured >> >> When I reboot, I do get the right address and everything seem to work. >> However *the service networking.service gets an error.* >> >> Interestingly, the original version of /etc/network/interfaces does not >> mention eth0, yet it starts correctly. Is there some other mechanism >> starting it? >> >> What is the correct way of configuring static ip for eth0? >> >> best >> Johan Ingvast >> >> -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/81b13002-aebc-46bf-b4ea-c53195695105n%40googlegroups.com > <https://groups.google.com/d/msgid/beagleboard/81b13002-aebc-46bf-b4ea-c53195695105n%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAG99bkoJj4h_DquhJ8vzbokJS0niFAbRVwAyqB5Vb4p7nnDk_w%40mail.gmail.com.
