Hi, As you are using the ActiveState distribution of Perl in Win32 environment, you can also post to the Perl-Win32 mailing list. The ActiveState ActivePerl 5.8 comes with adequate documentation. It also has a Perl Packet Manager that is used to install Perl modules. Consult the documentation on the PPM which comes with the installation.
If in doubt, ask your Win32 systems administrator on how to access the relevant documentation(I assume that you are not alone.)
Good luck,
Alfred Vahau IT Services University of Papua New Guinea Information Resources Centre Ph. 675 3267 277 Fax. 675 3267 187
----------------------------
From: Leon [mailto:[EMAIL PROTECTED] Sent: Friday, March 28, 2003 1:23 PM To: [EMAIL PROTECTED] Subject: newbie module question
Hi everyone,
I am really really new to perl. I know this is dumb but I am using perl in the win 32 environement (perl 5.8.0 build 804) from active state. I am trying to figure out how to install modules. Where do you get them from? How do you install them? Other things I need to know?
Thx again and please no flames I am new to this whole perl thing.
--------------------------------- Do you Yahoo!? Yahoo! Platinum - Watch CBS' NCAA March Madness, live on your desktop!
This may contain information exempt from mandatory disclosure under the Freedom of Information Act (FOIA). Exemption(s) __________ may apply.
-- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
