Passive - If set to a non-zero value then all data transfers will be done using passive mode. If set to zero then data transfers will be done using active mode.
-----Original Message----- From: RICHARD FERNANDEZ [mailto:[EMAIL PROTECTED] Sent: 20 November 2007 15:25 To: beginners@perl.org Subject: Net::FTP troubles with passive Hi Folks, I have a script that sends a file to a vendor. After running tcpdump I can see that it's trying to do a passive mode transfer which our firewall is having problems with. I would like to turn this off and specify an active mode transfer, but the doco for Net::FTP only talks about turning passive mode _on_. It's silent about turning it off, which would make me think that "off" should be the default. AFAIK, active/passive mode selection is a client issue... Has anyone seen this before? Thanks for any replies! richf -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] http://learn.perl.org/ This e-mail is from the PA Group. For more information, see www.thepagroup.com. This e-mail may contain confidential information. Only the addressee is permitted to read, copy, distribute or otherwise use this email or any attachments. If you have received it in error, please contact the sender immediately. Any opinion expressed in this e-mail is personal to the sender and may not reflect the opinion of the PA Group. Any e-mail reply to this address may be subject to interception or monitoring for operational reasons or for lawful business practices. -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] http://learn.perl.org/
