of 400MHz Kingston DDR1 ECC, two sata 250GB Maxtor, new CD-ROM and
so this is ddr1/pc3200, right?
Phoenix Trusted Server 1.03.2895
I think that bios version is quite out of date: http://www.tyan.com/support_download_bios.aspx?model=S.S2895
CPU0 MemClk 200MHz Tcl=3.0 Trc=3 Tras=8 Trp=3
200 gets doubled (ddr) to 400 mega-transfers per second, which is pc3200.
CPU1 MemClk 100MHz Tcl=??? Trc=0 Tras=Trp=0
this indicates that the memory isn't detected, I think. I think you have just two dimms installed, which would agree.
Resource conflict - PCI Mass Storage Controller in slot 01 Bus:01, Device:04, Function:00 was unable to run due to memory constraints.
that sounds like the device is requiring its PCI resources mapped to physical addresses occupied by memory. I would guess that there are bios options that would work around this. but I'd update the bios first.
Well, I am no system maintainer (there is nobody here that qualifies for that) and I can imagine a lot of different possibilities, from faulty RAM (that suspicious reading 200MHz and 100MHz, while they are 400MHz) on...
nah, the ram sounds fine. the issue is getting it to boot into the flash image, I think.
_______________________________________________ Beowulf mailing list, [email protected] To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
