Actually, I take that back. Only partially user error. My Tesla's do have an DVI output, but I was trying to connect to the VGA output.
At first, I thought I was just being stupid (see the last e-mail), then I remembered something, that may have partially redeemed me: Due to the location of the DVI input on the Tesla card, the chassis itself interferes with the DVI connector, so it's impossible to connect the DVI cable to the Tesla's DVI output. Not without customizing the chassis with a Sawzall or Dremel too, at least. The fix is simple: configure the BIOS to always default to the onboard VGA. Unfortunately, it's not obvious what the correct selection is. Here's the section of the manual on this, in it's entirety: Primary Video Controller Use this setting to specify the primary video controller boot order. Options include PCIE-GPP1-GPP2-GPP3a-PCI, PCIE-GPP2-GPP1-GPP3a-PCI, PCIE-GPP3a-GPP1-GPP2-PCI or PCI-PCIE-GPP1-GPP2-GPP3a. that make it pretty clear, doesn't it? Prentice Prentice Bisbal wrote: > Nevermind. User-error. > > Prentice > > > Prentice Bisbal wrote: >> Beowulfers, >> >> Are any of you having problems with the VGA console on your Microway >> Navion or Supermicro servers? >> >> About 2 months ago, I received for new Microway Navion Servers with >> Fermi GPUs. These servers are just rebranded SuperMicro servers with the >> H8DGG-QF motherboard. >> >> I had this problem when I first started working with these systems, but >> then it disappeared. Now that I'm trying to reinstall the OS on a couple >> of systems, I can no longer get a VGA console. >> >> Here's the symptoms: When I plug in the monitor on my crash, cart, it >> recognizes that there's a computer connected. Otherwise it would display >> the self-test message, indicating that NOTHING is connected. However, a >> split second after detecting it's connected to a computer, it goes right >> into power saving mode - the LED in Dell monitor's powerbutton goes >> from green to orange. >> >> The keyboard works, because the numlock LED goes on and off as expected. >> >> The GPU cards are Tesla cards that don't even have a display port on >> them, so I don't think I need to specify the on-board display in the >> BIOS, and if this needed to be done, I would assume that Microway would >> have done this before shipping the system. >> >> Am I making an ass out of myself by assuming this? I was able to get a >> console on these systems at one point without tinkering with the bios. >> >> > -- Prentice Bisbal Linux Software Support Specialist/System Administrator School of Natural Sciences Institute for Advanced Study Princeton, NJ _______________________________________________ Beowulf mailing list, [email protected] sponsored by Penguin Computing To change your subscription (digest mode or unsubscribe) visit http://www.beowulf.org/mailman/listinfo/beowulf
