Hi Murray, Thanks for the review. The normative SHOULD was used because it is possible to operate in Port-Active mode without the P/B in Ether A-D per ES (if port-active is setting the interface Down then the peer will not send any routes – there is no ‘B’).
It is just undesirable for convergence: the P/B give a hint to the remote that the entire port is Primary vs Backup, and that it need not wait for each individual Ether A-D per EVI update to P/B. All implementations I am aware of are doing it, but I should still circle back to co-authors/implementors before flipping it to a MUST. Regards, Luc André Luc André Burdet | [email protected]<mailto:[email protected]> | Tel: +1 613 254 4814 From: Murray Kucherawy via Datatracker <[email protected]> Date: Thursday, December 5, 2024 at 00:22 To: The IESG <[email protected]> Cc: [email protected] <[email protected]>, [email protected] <[email protected]>, [email protected] <[email protected]>, [email protected] <[email protected]> Subject: Murray Kucherawy's No Objection on draft-ietf-bess-evpn-mh-pa-11: (with COMMENT) Murray Kucherawy has entered the following ballot position for draft-ietf-bess-evpn-mh-pa-11: No Objection When responding, please keep the subject line intact and reply to all email addresses included in the To and CC lines. (Feel free to cut this introductory paragraph, however.) Please refer to https://www.ietf.org/about/groups/iesg/statements/handling-ballot-positions/ for more information about how to handle DISCUSS and COMMENT positions. The document, along with other ballot positions, can be found here: https://datatracker.ietf.org/doc/draft-ietf-bess-evpn-mh-pa/ ---------------------------------------------------------------------- COMMENT: ---------------------------------------------------------------------- In Section 3.2, bullet (g), why is this only a SHOULD? When might an implementer or operator decide to do otherwise? Same question around the SHOULD in Section 4.1.
_______________________________________________ BESS mailing list -- [email protected] To unsubscribe send an email to [email protected]
