I doubt that it is documented anywhere but in the forum and the source. I vaguely remembered there was functionality like this in J7 for switching from the jconsole to jhs and back again. I figured that it was probably in the jhs locale, went looking and found jfe_jhs_ which seemed to work.
Searching the forums just now turned up the following post - the functionality is similar but the location has changed since then. http://www.jsoftware.com/pipermail/beta/2009-November/003513.html On Sun, Mar 17, 2013 at 4:15 AM, Murray Eisenberg <[email protected]> wrote: > Where is this documented? I can't access any help from the JQt 801 menu. Is > it referenced on the wiki, and if so, where? > > On 17 Mar 2013 00:59:04 +1300, Ric Sherlock <[email protected]> wrote: > >> Once you have launched a JHS session from the JQt IDE (Run|Launch >> JHS), you can transfer control back to the JQt IDE by running the >> following command in the jhs session: >> jfe_jhs_ 0 >> The following command in the JQt IDE will transfer control back to the >> jhs session: >> jfe_jhs_ 1 > > --- > Murray Eisenberg [email protected] > Mathematics & Statistics Dept. > Lederle Graduate Research Tower phone 413 549-1020 (H) > University of Massachusetts 413 545-2838 (W) > 710 North Pleasant Street fax 413 545-1801 > Amherst, MA 01003-9305 > > > > > > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
