I think I found the cause of the error. wd1 is a verb calling the jqt.dll. On my system, its current path includes an accentuated character in the user name.
If it is a real requirement, the installation process could check if the path has only ASCII characters and refuse the install if not. I uninstalled and reinstalled in another dir. jqt starts ok. Now the path of j803-user still has the same non ASCII. Will this cause problems down the road? ~ Gilles ---------- Original Message ----------- From: bill lam <[email protected]> To: [email protected] Sent: Fri, 24 Oct 2014 09:38:25 +0800 Subject: Re: [Jbeta] Domain error launching jqt > I'm not sure. Those j803 AIO were copied from j802, the real j803 > AIO have not yet built. > > Did you perform a clean install? > On Oct 24, 2014 9:20 AM, "Gilles Kirouac" <[email protected]> wrote: > > > Trying J803 after full standard install of AIO installer in Win32. > > > > Launched jconsole: ok. > > > > Launched jqt: > > |domain error: wd1 > > | 'r c l p n'=. wd1(,y);(#,y);(,2);(,0) > > > > Executed updatejqt. > > > > Launched jqt: same error. > > > > Checked the beta forum, saw nothing related. > > > > ~ Gilles > > > > ---------------------------------------------------------------------- > > For information about J forums see http://www.jsoftware.com/forums.htm > > > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm ------- End of Original Message ------- ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
