Sounds like the new opengl stuff works and the problems were mixing your old
application with the new stuff without making the necessary (though few)
changes.
I suggest that you work your way through the lab opengl intro.
----- Original Message -----
From: "Brian Schott" <[EMAIL PROTECTED]>
To: "Beta forum" <[email protected]>
Sent: Saturday, April 15, 2006 11:34 AM
Subject: Re: [Jbeta] Mac: testopengl failure
Encouraged by Joey experience I tried more
experiments and find the much of openGL does work on my Mac,
too. The cause of the previous error was the following code
which worked in J5:
testdlls=: 3 : 0
0!:0 <jpath'~system\extras\util\testogl.ijs'
'All OK.'
)
In the opengl demo, the Title page does not display
any contents.
Another error I get with my own code (The code can
be found at
http://www.jsoftware.com/jwiki/BrianSchott/code/turtleGraphics/3Dogl
and clicking on tgsj3ogl.ijs ). The error is triggered by a
call to glinit as follows after commenting out the call
to the above verb: "testdlls''".
load '/Users/brian/j601/addons/turtle/tgsj3ogl.ijs'
Look for examples near the beginning of the script.
|value error: glinit
| glinit''
Perhaps there is a document which explains the new
openGL release. I could not find it in the J6 release notes,
though. Oh, wait .... I remember now: Raul's jwiki
contribution. I'll go there.
(B=)
On Fri, 14 Apr 2006, Joey K Tuttle wrote:
+ On my 20" G5 iMac, the opengl lab runs fine in the new beta.
+ The demos start to run OK (and are VERY impressive when in
+ fullscreen mode on the large display) but I do get an error
+ after the colored cube is displayed. The dialog box is
+
+ wdhandler
+
+ error in: sys_timer
+
+ syntax error: gldemo_slides_jgldemo_wd_fn~"
+
+
+ version ''
+ j601/beta/2006-02-27/10:25
+ Running in: Darwin
+
+
+ - joey
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
