After rear ending a car and crunching my mid-'80's Centurion Elite ??, I got an '84 Trek 620 to replace it. Switched over B17, Noodle Bar, great wide opening toe cage and Jandd racks, but the fork is too tight to fit the stainless Berthoud fender. I love both the bike and the fenders. Any ideas on how to make this work?
I'm thinking of cutting the fender in half and bolting it to the crown hole (somehow). If I do cut the fender, I was thinking of making the back section longer so that it keeps spray off my feet, is there a reason front fenders don't extend lower than they do? Also not sure if I should bolt the front end to the front of the crown, would it be stable? The Jandd front rack has a solid top that might take care of spray out front. (I've also one of the plastic strut attachment thingy, again, and will be ordering another replacement from PWC. Second time I've lost this part!) Thanks, Philip --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Bicycle Lifestyle" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/bicyclelifestyle?hl=en -~----------~----~----~----~------~----~------~--~---
