thank you! ________________________________ From: Joseph Donaldson <[email protected]> Sent: Thursday, April 30, 2020 5:56 PM To: [email protected] <[email protected]>; Julián Herrera <[email protected]> Subject: Re: [bigloo] Building Bigloo on Ubuntu with JVM support
Hello, Julian, I suspect it skipped building bgljfile since you originally build without jvm support. Can you cd into the bde directory and run make? This should build bgljfile. Once done, you should be able to run make again from the top-level and have the compilation succeed. Best Regards, Joe On Thursday, April 30, 2020, 2:01:32 PM PDT, Julián Herrera <[email protected]> wrote: I ran ./configure --jvm=yes configure runs fine and spits out a summary that looks accurate. I run make, that runs for a couple seconds but then stops at the following: /home/jules/Code/bigloo4.3g/bin/bgljfile.sh: 19: exec: /home/jules/Code/bigloo4.3g/bin/bgljfile: not found Makefile:570: recipe for target '.jfile' failed make[2]: *** [.jfile] Error 127 make[2]: Leaving directory '/home/jules/Code/bigloo4.3g/comptime' Makefile:403: recipe for target 'bigloo' failed make[1]: *** [bigloo] Error 2 make[1]: Leaving directory '/home/jules/Code/bigloo4.3g/comptime' Makefile:168: recipe for target 'boot-c' failed make: *** [boot-c] Error 2 bgljfile.sh ends with a call to exec a file which does not exist Previously I had built bigloo successfully just running (configure, make, make install), didn't realize the JVM integration required a seperate flag. So this is my 2nd attempt (after running make clean) and I can't passed this step.
