Sorry for jumping in, so from your information I understand that when I have updated zone file at the master I should use `rndc reload <zone-name>` instead `rndc retransfer <zone-name>` to transfer the new zone file to other slaves, is it right ?
Regards, T. Kittiratanachai (Te) On Fri, May 23, 2014 at 9:45 AM, Mark Andrews <[email protected]> wrote: > > In message <[email protected]>, > gr > [email protected] writes: > > > > > No it isn't. It is saying the zone isn't found. "unknown command" is > > > returned for unknown commands. > > > > > > rndc: 'xxxxx' failed: unknown command > > > > Ok, but the zone IS there. > > > > It's found by other rndc commands. > > > > It's loaded by bind on start. > > > > It's transferred to slaves, again on (re)start. > > > > Why isn't it finding the zone? > > Presumably it is not a slave or a stub. retransfer is only applicable to > slave and stub zones. > > > _______________________________________________ > > Please visit https://lists.isc.org/mailman/listinfo/bind-users to > unsubscribe > > from this list > > > > bind-users mailing list > > [email protected] > > https://lists.isc.org/mailman/listinfo/bind-users > -- > Mark Andrews, ISC > 1 Seymour St., Dundas Valley, NSW 2117, Australia > PHONE: +61 2 9871 4742 INTERNET: [email protected] > _______________________________________________ > Please visit https://lists.isc.org/mailman/listinfo/bind-users to > unsubscribe from this list > > bind-users mailing list > [email protected] > https://lists.isc.org/mailman/listinfo/bind-users >
_______________________________________________ Please visit https://lists.isc.org/mailman/listinfo/bind-users to unsubscribe from this list bind-users mailing list [email protected] https://lists.isc.org/mailman/listinfo/bind-users
