I think one of the problems is that the BFD protocol doesn’t seem to accept the ipv4/6 channels like the other protocols. That would probably already solve this?
> On 5. Nov 2020, at 17:12, Stefan Plug <[email protected]> wrote: > > Hey guys, > > BIRD2 2.0.7 > > I want to run 2 BIRD2 Daemons, one with ipv4 config and one with ipv6 config, > just like as with BIRD1 this works fine for BGP. > > However, I have noticed that it doesn’t seem possible (?) to point BFD within > a daemon to only listen to ipv4 or ipv6 which will make both daemons listen > to both protocols regardless of if they even have any ipv4 or ipv6 > configuration. > > This means that if daemon1 was first then all BFD packets will got to daemon1 > and not to daemon2, so no BFD will come up in daemon2. > > Is there a way to tell BIRD2 to only listen to ipv4 or ipv6 with BFD? > > Kind regards, > > Stefan > > > -- > Stefan Plug > Network Engineer (EU) > > Phone: +49 160 2504854 > > ECIX, a Megaport company > PEERING GmbH > Tauentzienstraße 11 > 10789 Berlin Germany > > Office: +49 30 233 24 16-0 > Web: www.ecix.net > > Sitz der Gesellschaft: Berlin, Germany. Registergericht: Amtsgericht > Charlottenburg, HRB 97752B > Vertretungsberechtigte Geschäftsführung: Vincent English, Bevan Slattery, > Prokuristen: Stefan Wahl > This message is intended for the addressee named and may contain confidential > information. If you are not the intended recipient please delete it and > notify the sender. >
