Hi Everyone, For those who have experience with Redfone products, can you please weigh in on these questions. I need to know the in and out of these products for a better decision to be made: 1- How does the 2 x Quad-port fonebridge in 1U rack mount work when one wants to connect each PRI to separate box? Is there a UI portal for the fone bridge that allows the setup? 2- What if one wants to send all the ports to a single server? Does the server have to have 8 NIC ports for this? 3- Is there any specific NIC type requirements for this product? 4- How good of a product is? It's amazing that it's expandable and independent. So, it can be used as a redundancy measure but is it as good as a Sangoma PRI card? 5- If a single Quad-port is added, is adding a second Quad-port like a hot swap install? or does it require full configuration? 6- Do you prefer to have the on-board echo cancel version? 7- I see that their Support is not impressive. At least not from their statment on the site to allow 5 WHOLE DAYS for response time. Have you had small and big problems that you thought could have been taken care of in few minutes and waited few days for it? 8- What is the difference between the fonebridge version 2 and older verison? 9- Are there any local Canadian distributer of the Redfone products? Non listed on their site. 10-*** Is there another quality product that you have came by that does the same job or better? Thanks,Bruce
