On May 16, 2010, at 11:38 AM, ekate wrote:
> Everytime I try to run an application with quicksilver, I type it's
> name, but results show the application from the catalog, instead of
> the application, so I cannot run it. What could I do???
I usually have thos problem when Quicksilver was recently launched, but it goes
away after indexing is complete. I am also getting applications using the
Spotlight plugin instead of the normal applications source, so my setup isn't
typical.
Anyway, if this is constantly a problem no matter how long QS has been running,
clearing your cache will probably fix it. Quit Quicksilver, remove these two
folders, then start it again and wait a minute.
~/Library/Caches/Quicksilver
~/Library/Caches/com.blacktree.quicksilver
--
Rob McBroom
<http://www.skurfer.com/>
Because it screws up the order in which people normally read text.
Original message:
> Why is it bad to top-post your reply?
