Thanks for the info on this! On Tuesday, August 27, 2013 4:57:18 AM UTC-7, Matthew McNeil wrote: > > Hi all, > I have a trigger set up for Quicksilver's Google Search which I use > constantly: > > > <https://lh6.googleusercontent.com/-oNh7C1czjuA/UhyTkZasnaI/AAAAAAAAJro/bdK63d_7gTg/s1600/trigger+setup.PNG> > > Formerly when I'd invoke the trigger I'd consistently get this state > > > <https://lh3.googleusercontent.com/-LnsgCfbRP8U/UhyTsI8Kv0I/AAAAAAAAJrw/xEEDbpyEJwg/s1600/before.PNG> > > where the search input field was focused and I could immediately type. > > Now (I believe after the update to 1.1?), invoking the trigger again puts > me into the state shown here: > > > <https://lh3.googleusercontent.com/-ESqtJsMMC1M/UhyT4t5IKsI/AAAAAAAAJr4/mNe74iZ0WEU/s1600/current.PNG> > > > where I seem to have to type "." to switch to text entry before I can > begin a search with new search terms. > > Is there any way to restore the old behavior and/or configure Quicksilver > or my trigger to always start in text entry mode? > > Thanks much for any insight, > Matt > > > >
-- You received this message because you are subscribed to the Google Groups "Quicksilver" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/blacktree-quicksilver. For more options, visit https://groups.google.com/groups/opt_out.
