On 6/3/07, Andrew <[EMAIL PROTECTED]> wrote: > Hello to all! Hello
> 1-st problem: motherboard is nforce-3. Ethernet module is nforcedeth. I > build it as a module. After booting i have no eth0 interface. But module > is loaded. No changes is made from previous system (linux-2.6.20). Syslog > - "eth0: forcedeth.c: subsystem: 01458:e000 bound to 0000:00:05.0". But > netinit writes "no eth0 interface"... I have no idea. what does ifconfig eth0 output? How about ifconfig -a (i think that's the syntax)? Is the module getting loaded before your network init scripts? > second: hal-0.5.9 doesn't mount nor flashdisk, nor cdrom. When booting, it > did something with is (cdrom spinning, flash is "flashong" :). In syslog > see strange message - sd 2:0:0:0: Attached scsi removable disk sdb. > 2:0:0:0: Attached scsi generic sg1 type 0. I have been getting a time getting hal working myself, so i can't help you get it there, however i can explain the syslog messages. Whenever I plug in a flash drive (with or without hal), I get those messages in syslog. I can't help much because I'm out of town right now and don't have access to a good computer, maybe i can help more when i get back into town. good luck... -- /me -- http://linuxfromscratch.org/mailman/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
