pete wrote:
> >> forcedeth 0000:00:07.0: ifname eth0, PHY OUI 0x50ef @ 0, addr
> >> 00:22:68:72:e6:a1
> >> forcedeth 0000:00:07.0: highdma pwrctl mgmt lnktim msi desc-v3
>
> >> cdc_ether 2-7:1.1: eth1: register 'cdc_ether' at usb-0000:00:02.0-7, CDC
> >> Ethernet Device, 00:40:7b:71:9b:f3
> > What is the output of lspci|grep Ethernet
> The output of lspci|grep Ethernet:
> 00:07.0 Bridge: NVIDIA Corporation MCP61 Ethernet (rev a2)
This doesn't look right. The only thing you have is a bridge? You
should have two ethernet cards.
> > Also what are the contents of /etc/udev/rules.d/70-persistent-net.rules?
> The contents of 70-persistent-net.rules is:
> # This file was automatically generated by the /lib/udev/write_net_rules
> # program, run by the persistent-net-generator.rules rules file.
> #
> # You can modify it, as long as you keep each rule on a single
> # line, and change only the value of the NAME= key.
>
> # net device module
> SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",
> ATTR{address}=="00:40:7b:71:9b:f3", ATTR{dev_id}=="0x0",
> ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
>
> # net device module
> SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*",
> ATTR{address}=="00:22:68:72:e6:a1", ATTR{dev_id}=="0x0",
> ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"
This looks OK.
> Provided that the interfaces are recognised correctly at boot up, they
> both configure OK (etho via dhcpcd and eth1 via ipv4).
> There is no hotplugging available (as yet). When an interface is connected
> (except at boot up) it must be manually configured using "ifup ethx".
No, our scripts don't support hotplugging either. There would have to
be some way to call ifup automatically.
> This hardware setup has worked well for many years on various versions of
> LFS/BLFS builds (up to LFS-7.0), it is only on this latest version (LFS-7.2)
> that I have had problems.
>
> If there have not been any significant changes to the software since
> LFS-7.0, maybe I should try a rebuild.
I wouldn't think reinstalling the whole thing would be needed. You
could try installing an older version of udev, say version 173, using
the LFS -7.0 instructions.
Another thing to try is to temporarily disable the udev and udev_retry
scripts and reboot. Then run '/lib/udev/udevd --debug' followed by
'/sbin/udevadm trigger --action=add --type=subsystems' and see what is
printed to stderr.
-- Bruce
-- Bruce
--
http://linuxfromscratch.org/mailman/listinfo/blfs-support
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page
