Hello
I have recently finished installing LFS 7.2, and then onto BLFS 2013-02-23
I went up to chapter 3, and did the acl, attr, ca certs, iptables, and
openssl parts from chapter 4.
Then I went to the networking section and installed ISC DHCP client,
wget, wireless tools, links and all required and recommended
dependencies, except relating to X.
Then I installed wpa_supplicant (and libnl beforehand) without dbus or qt.
I rebooted, and wpa_supplicant seemed to start fine, and ip addr
reported that wlan0 had an ip address, except I could not ping my
wireless router or my modem, or ping a url or open a url with links.
root [ ~ ]# ifdown wlan0
* ping dhclient on the wlan0 interface... [ OK ]
* ping wpa_supplicant on the wlan0 interface... [ OK ]
* Bringing down the wlan0 interface... [ OK ]
root [ ~ ]# ifup wlan0
Bringing up the wlan0 interface...
Starting wpa_supplicant on the wlan0 interface...[ 271.770568]
b43-phy0: Loading firmware version 666.2 (2011-02-23 01:15:07)
[ 271.829215] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
* [ OK ]
Starting dhclient on the wlan0 interface...[ 280.634519] IPv6:
ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
* [ OK ]
root [ ~ ]# ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UP qlen 1000
link/ether 04:7d:7b:39:80:37 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.1/24 brd 192.168.1.255 scope global eth0
inet6 fe80::67d:7bff:fe39:8037/64 scope link
valid_lft forever preferred_lft forever
4: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
qlen 1000
link/ether 20:10:7a:2e:cc:ba brd ff:ff:ff:ff:ff:ff
inet 192.168.1.65/24 brd 192.168.1.255 scope global wlan0
inet6 fe80::2210:7aff:fe2e:ccba/64 scope link
valid_lft forever preferred_lft forever
root [ ~ ]# [ 293.198603] cfg80211: Calling CRDA to update world
regulatory domain
ping [ 303.218491] kworker/u:0 (5) used greatest stack depth: 3496
bytes left
192.168.1.255
PING 192.168.1.255 (192.168.1.255): 48 data bytes
[ 388.149868] cfg80211: Calling CRDA to update world regulatory domain
[ 393.579256] cfg80211: Calling CRDA to update world regulatory domain
^Z
[4]+ Stopped ping 192.168.1.255
root [ ~ ]# ping 192.168.1.254
PING 192.168.1.254 (192.168.1.254): 48 data bytes
[ 435.134727] cfg80211: Calling CRDA to update world regulatory domain
60 bytes from 192.168.1.1: Destination Host Unreachable
Vr HL TOS Len ID Flg off TTL Pro cks Src Dst Data
4 5 00 4c00 0000 0 0040 40 01 61b6 192.168.1.1 192.168.1.254
^Z
[5]+ Stopped ping 192.168.1.254
root [ ~ ]# [ 448.756344] cfg80211: Calling CRDA to update world
regulatory domain
Does anyone have any idea what might be causing this?
Thanks,
Ethan
--
http://linuxfromscratch.org/mailman/listinfo/blfs-support
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page
