> ----- Original Message ----- > From: [email protected] > Sent: 03/25/13 10:37 PM > To: BLFS Support List > Subject: Re: [blfs-support] Autofs problem on LFS7.2
> > > > > > > > When you say 'it hangs': normally it'll not go back to the shell > > > > command prompt > > > > but instead just sit waiting to output more diagnostics. > > > > What happens if you put in a usbstick and try to list its contents via > > > > '\ls -laF /testautomount/sandisk' - do more diagnostic messages get > > > > printed? If > > > > so, can you post them here, please? Thanks. If it seems that nothing is > > > > happening, > > > > just wait for another minute or so. > > > > I only get the following again, but only after having to Ctr C to get out > > no activity after 10min > > $ > > total 8 > > drwxr-xr-x 2 root root 4096 Mar 23 09:38 ./ > > drwxr-xr-x 3 root root 4096 Mar 23 09:38 ../ > > $ > > > > > Yes, if you ctrl-c to quit automount, then it's not running, and so you > _would_ > see an empty directory, because nothing's automounted there, because > automount > is not running, because it's just been ctrl-c quitted. > > > > > > $ Can you also run with specifying the master-map file explicitly: > > automount -v -f -d /etc/auto.master > > Starting automounter version 5.0.7, master map /etc/auto.master > > using kernel protocol version 5.02 > > lookup_nss_read_master: reading master file /etc/auto.master > > parse_init: parse(sun): init gathered global options: (null) > > open_mount:244: parse(sun): cannot open mount module nfs > > (//lib/autofs/mount_nfs.so: undefined symbol: auth_put) > > lookup(file): failed to open parse context > > no mounts in table > > > > This is with usbstick installed > > $ > > > > > OK: it's just choking before parsing the master-map file. I'd go on and do > the > recompile approach, per earlier most-recent message today. > > > > $ grep -E 'N(F|I)S' /boot/config > > grep: /boot/config: No such file or directory > > $ > > > Sorry, that should've been $ grep -E 'N(F|I)S' /boot/config* - did you mean .config? There is no output anyhow. $ > > > > > > Did you use the same compile/install instructions for autofs as in the > > > > blfs book; > > > > or adjust them at all? I guess you at least added the kernel config > > > > stuff for > > > > AUTOFS4 . Did you install NFS: and if so any deviations from the book? > > > > Compiled autofs as in book. I was mistaken, did 'client-only'install of > > OpenLDAP. Did do install of Cyrus. Did not install NFS. > > > > > OK. Will leave that info present here in case need to followup on it. But I'd > go the recompile route from here. Will go down the recompile route and get back to you. thanks MAC -- http://linuxfromscratch.org/mailman/listinfo/blfs-support FAQ: http://www.linuxfromscratch.org/blfs/faq.html Unsubscribe: See the above information page
