On 12.1.2014 16:39, Niels Terp wrote:
> Hi there,
>
> Now I have completed the full chapter 25 - X Libraries, and I have
> installed both QT4 and QT5, and I have also installed qtchooser and
> configured QT4 to be the default.
>
> Now in KDE, when I attempt to build attica, I get the error:
>
> CMake Error at CMakeList.txt:10 (find_package):
> Could not find a package configuration file provided by "ECM"
> (requested version 0.0.6) with any of the following names:
>
> ECMConfig.cmake
> Ecm-config.cmake
>
> I have made a temporary "solution" by deleting QT5, installing attica
> (which now builds perfectly) and then reinstalling QT5 in the end of
> the installation script.
>
> But this is not a very elegant solution, and it makes it nessesary to
> have the QT5 RPM file from the beginning - and when everything is
> finished you would not have that, because it is generated and
> installed in another chapter.
>
> Greetings
>
> Niels
>
You're obviously using older instructions. Current instructions have:
cmake -DCMAKE_INSTALL_PREFIX=$KDE_PREFIX \
-DCMAKE_BUILD_TYPE=Release \
-DQT4_BUILD=ON
And further below in command explanations:
-DQT4_BUILD=ON: This switch forces the package to build against Qt4 even if
Qt5 is present on the system. Remove it if you want to build the package
against Qt5.
--
Thank you Armin, I will try this tomorrow. And you are right, I'm using BLFS
7.4 "Stable" - I can see I have to make it a habit to check the development
version when I have a problem.
Niels
--
http://linuxfromscratch.org/mailman/listinfo/blfs-support
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page
