On 06/30/2014 08:01 AM, emilianoriva wrote:
I looked in the .config file and CONFIG_WIRELESS is set to yes, means it wireless support?

It means that you have set up "general" wireless support. It does not configure your specific driver. You need to identify your specific wireless device and then enable it in the kernel configuration. I, too, use the rt2800 driver for Ralink.

lspci gives:

02:00.0 Network controller: Ralink corp. RT3290 Wireless 802.11n 1T/1R PCIe

Then in whatever way you set the options in your kernel ,config go to:

Device drivers-->Network device support-->Wireless LAN-->Ralink driver support.

You will be presented with the choices for the various Ralink devices. I don't know how you discover whether or not you need firmware. (I think you get a report of something missing if you run "dmesg" after you boot.) I didn't need anything extra for my setup.

Make sure you also have enabled 802.11 support. It's all under Networking. "Help" is your friend. :)

Dan



--
http://lists.linuxfromscratch.org/listinfo/blfs-support
FAQ: http://www.linuxfromscratch.org/blfs/faq.html
Unsubscribe: See the above information page

Reply via email to