I purchased a few years ago a headset with a tone modulator that would start
making a tone when you had the dish lined up with the satellite.  It made
things simple and could be done by a blind person.  The more in line you had
the dish, the higher the pitch was.  You could buy them from your local
company, but that took away business.  I purchased it from OPM satellite on
line.

Loren
----- Original Message ----- 
From: "Ray Boyce" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Sunday, August 13, 2006 12:37 AM
Subject: [BlindHandyMan] How to tune a Satellite Dish


Hi
Your new dish is installed, and now you just need to get that antenna tuned
for perfect reception and the maximum number of channels!

Steps:
1.
Ensure that your satellite antenna meets three conditions: The line-of-sight
view to the particular satellite is free of obstacles and obstructions that
will block the incoming signal to the antenna; the mast supporting the
antenna is rigidly mounted and level; and the reflector part of the
satellite antenna
(the dish) is not warped.

2.
Adjust the antenna reflector azimuth angle to the position given by the
manufacturer for that particular satellite. This adjustment is the east-west
movement
of the reflector on the mount and is given in azimuth degrees.

3.
Adjust the elevation-look angle to the position given by the manufacturer of
the satellite of interest. This adjustment is from the horizon to the sky
and
is given as elevation in degrees from that point. These two degrees form the
orbit degree slot or window of the satellite to be received by your antenna.

4.
Ensure that the antenna signal line is connected to the receiver and the
receiver is turned on and positioned on a beacon channel (a beacon channel
is a
channel being transmitted from the satellite to allow you to peak your
antenna to it).

5.
Begin tuning by slowly moving the reflector first to the east in one-degree
increments for a total of three degrees, then in the opposite direction
(west)
while monitoring the receiver's signal meter.

6.
Peak the signal to the highest scale at this point. Peaking the signal using
a signal meter is most recommended due to the meter's signal sensitivity.

7.
Snug the antenna azimuth adjustment slightly on the mount once the signal
level is maximized.

8.
Perform the same procedure as in steps 4 through 6, using the elevation
adjustment first up and then down for peaking. Snug the antenna elevation at
this
point.

9.
Ground the antenna and the signal line entrance into the residence to
electrical code standards.



To listen to the show archives go to link
 http://acbradio.org/handyman.html
or
ftp://ftp.acbradio.org/acbradio-archives/handyman/

The Pod Cast address for the Blind Handy Man Show is.
http://www.acbradio.org/news/xml/podcast.php?pgm=saturday

The Pod Cast address for the Cooking In The Dark Show is.
http://www.gcast.com/u/cookingindark/main.xml

Visit The New Blind Handy Man Files Page To Review Contributions From
Various List Members At The Following Address:
http://www.jaws-users.com/handyman/
Visit the new archives page at the following address
http://www.mail-archive.com/[email protected]/
For a complete list of email commands pertaining to the Blind Handy Man list
just send a blank message to:
[EMAIL PROTECTED]
Yahoo! Groups Links









To listen to the show archives go to link
 http://acbradio.org/handyman.html
or
ftp://ftp.acbradio.org/acbradio-archives/handyman/

The Pod Cast address for the Blind Handy Man Show is.
http://www.acbradio.org/news/xml/podcast.php?pgm=saturday

The Pod Cast address for the Cooking In The Dark Show is.
http://www.gcast.com/u/cookingindark/main.xml

Visit The New Blind Handy Man Files Page To Review Contributions From Various 
List Members At The Following Address:
http://www.jaws-users.com/handyman/
Visit the new archives page at the following address
http://www.mail-archive.com/[email protected]/  
For a complete list of email commands pertaining to the Blind Handy Man list 
just send a blank message to:
[EMAIL PROTECTED] 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/blindhandyman/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to