Hi
When you're done boating, you'll need to pack up your vessel and take it home. 
Here's how to get it back on the trailer.
   
Steps:
1.
Pull the boat up to a dock or beach near the boat ramp.
  
2.
Disconnect the fuel line.
  
3.
Tilt the outboard motor up and lock it, if so equipped.
  
4.
Back the trailer down the ramp until water touches the rear wheels. Don't get 
the vehicle's wheels into the water.
  
5.
Move the boat up to the trailer and centre it.
  
6.
Release the tilt lock, if so equipped.
  
7.
Release the ratchet lock and pull the retrieval line out from the winch. 
Smaller boats may load by hand.
  
8.
Attach the retrieval line to the bow of the boat.
  
9.
Reset the winch lock.
  
10.
Crank the boat onto the trailer. Watch how it rides up onto the trailer. You 
may need to push it back to line it up again.
  
11.
Lock the tilt lock if it didn't lock automatically.
  
12.
Drive up the ramp to a spot where you'll be out of the way.
  
13.
Remove any remaining gear and the fuel tank if it isn't secured.
  
14.
Collapse and secure any awnings or similar covers.
 
15.
Pull the drain plug and release accumulated water.
16. Pull into a Wash Down area and connect fresh water to your motor and run 
your moter to remove salt water and wash down your boat.
Connect Tie  down straps and other fasteners.
  
17 If cleaning   tables are provided clean your fish,  generally water and a 
Shute is provided for waste material.
18 Place all rubbish in bins provided and leave the area clean and free from 
your day's outings. 
   They're often quirky, but with proper preparation, the outboard will be your 
friend.
   
Steps:
1.
Sit facing the motor.
  
2.
Tilt the motor back if it has been locked in the "up" position.
  
3.
Open the tank vent.
  
4.
Move the gearshift lever to neutral.
  
5.
Set the choke between half and full.
  
6.
Adjust the throttle to the "start" position.
  
7.
Prime the fuel system by squeezing the gas-line bulb until it feels firm.
  
8.
Pull the manual starter chord, or press the starter button on motors with 
electric starters.
  
9.
Reduce the choke and throttle after the motor starts.
  
10.
Adjust the choke if your motor doesn't start after three or four tries.
   
Tips:
 
Some outboard motors come equipped with a kill switch. It usually takes the 
form of a clip that attaches to your wrist with a plastic curly cord. If you
fall overboard, the motor stops. The motor won't start unless the clip is in 
place.
   
 
Warnings:
 
Excessive cranking can damage a motor. Engage an electric starter for no more 
than 5 seconds at a time.
   
  

**********************************************************************
This message and its attachments may contain legally
privileged or confidential information. If you are not the
intended recipient, you must not disclose or use the
information contained in it. If you have received this e-mail
in error, please notify the sender immediately by return
e-mail and delete the e-mail.

Any content of this message and its attachments which
does not relate to the official business of Eraring Energy
must be taken not to have been sent or endorsed by
Eraring Energy. No warranty is made that the e-mail or
attachment(s) are free from computer virus or other defect.
**********************************************************************



[Non-text portions of this message have been removed]



To listen to the show archives go to link
 http://acbradio.org/handyman.html
or
ftp://ftp.acbradio.org/acbradio-archives/handyman/

The Pod Cast address for the Blind Handy Man Show is.
http://www.acbradio.org/news/xml/podcast.php?pgm=saturday

The Pod Cast address for the Cooking In The Dark Show is.
http://www.gcast.com/u/cookingindark/main.xml

Visit The New Blind Handy Man Files Page To Review Contributions From Various 
List Members At The Following Address:
http://www.jaws-users.com/handyman/
Visit the new archives page at the following address
http://www.mail-archive.com/[email protected]/  
For a complete list of email commands pertaining to the Blind Handy Man list 
just send a blank message to:
[EMAIL PROTECTED] 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/blindhandyman/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 


Reply via email to