I thought the part about an installers bit was very enlightening. I've done dozens of these if not 50, and have always used teflon tubing where possible. Sounds like that drill bit will be a quarter hour and drop of sweat easier when feeding the wire through. Taping it to a coat hanger also works well.
Thanks! On Fri, 24 Nov 2006, David Ferrin wrote: > Great post my friend, I'm working on a few more ideas for you to > investigate. > David Ferrin > personal email address > [EMAIL PROTECTED] > Consciousness is that annoying time between naps. > ----- Original Message ----- > From: "Ray Boyce" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Sunday, November 26, 2006 3:24 AM > Subject: [BlindHandyMan] How to Instal a Telephone Jack > > > Hi > Even in this world of wireless technology and cell phones, many of us still > need access to wired telephones, especially when the electricity goes down. > If the telephone lines in your home don't go where you need them, installing > an extension jack (plug in) is a job you can handle. > > Instructions > . STEP 1: Gather the tools and materials you will need: > > Wire stripping pliers > Needle nose pliers > Screwdrivers > Telephone wire > Telephone jack > Installer drill bit > Cable staples > . STEP 2: Determine where you want to install the new telephone jack as well > as where the nearest existing jack is located. > . STEP 3: Measure the distance from the existing jack to where you want to > install the new jack. Include the total distances along baseboards and > around > doors in your calculations. Go to your local home store to buy your your > telephone jack and telephone wire (it's cheap so get a few feet extra). > . STEP 4: Run your telephone wire from the existing jack (be sure you leave > few extra inches) to where you want to your new jack to go. If you need to > go > through an interior wall, drill a small hole in the drywall and pass the > wire through. > . STEP 5: Skin 2 inches of the grey insulation from the telephone wire at > the existing jack. Inside will be four wires: red, green, black and yellow. > Skin > about 1 inch of insulation from each wire. > . STEP 6: Remove the cover of the existing jack; loosen the screws holding > the wires to the terminals and, using your needle nose pliers, attach > similar > colored wires to each terminal (red to red, green to green, black to black > and yellow to yellow). > . STEP 7: Repeat the wire skinning detailed above at the new jack location > and attach your telephone wire to the terminals inside the jack that are > marked > red, green, yellow and black. > . STEP 8: Fasten your new jack to the baseboard. Some jacks come with > double-sided tape for installation, but it's often just as easy to use a > small screw > to attach the jack. > . STEP 9: Secure the telephone wire you have run, either by tucking it under > the baseboard or by stapling it with a staple gun and staples designed to > fasten > cables. (Be careful; you don't want any staples going through the telephone > wire). > > Tips & Warnings > . You can get an "installer's" drill bit at your home store. This is a long > bit (about 18 inches in length) that makes it easy to drill through an > interior > wall from one side. The bit also has a small hole near the tip that you can > use to thread the telephone wire through the hole you have just drilled. > . Telephone lines can carry a very small amount of electrical current, but > it is not enough to give you a shock. > . An alternative to running wires on the surface of your walls and floors is > to "fish" wire through the walls. > . When you are running your telephone wire, keep the telephone wire at least > 6 inches away from any electrical wiring. This is for your own safety and to > ensure the electrical current doesn't cause any interference on the > telephone line. > > > > To listen to the show archives go to link > http://acbradio.org/handyman.html > or > ftp://ftp.acbradio.org/acbradio-archives/handyman/ > > The Pod Cast address for the Blind Handy Man Show is. > http://www.acbradio.org/news/xml/podcast.php?pgm=saturday > > The Pod Cast address for the Cooking In The Dark Show is. > http://www.gcast.com/u/cookingindark/main.xml > > Visit The New Blind Handy Man Files Page To Review Contributions From > Various List Members At The Following Address: > http://www.jaws-users.com/handyman/ > Visit the new archives page at the following address > http://www.mail-archive.com/[email protected]/ > For a complete list of email commands pertaining to the Blind Handy Man list > just send a blank message to: > [EMAIL PROTECTED] > Yahoo! Groups Links > > > > > > > >
