In a recently completed project I used plywood and applied iron on tape to the edges. Since the tape is wider than the thickness of the wood I had to trim it off somehow. I spent several bucks on trimmers but I found the best way is to use a wood chisel. The problem is that the corner of the chisel wants to dig into the surface of the wood. My solution was to put a small piece of duck tape over that corner. Just keep the flat side of the chisel against the surface and push it along. the tape will be left just a bit above the wood but a few strokes of hand sanding will take it down to be even. So, don't waste your money on those trimmers.
Regards. Max. K 4 O D S. Email: [EMAIL PROTECTED] Transistor site http://www.funwithtransistors.net Vacuum tube site: http://www.funwithtubes.net Music site: http://www.maxsmusicplace.com To subscribe to the fun with tubes group send an email to, [EMAIL PROTECTED]
