No wife... The lady I am dating knows less about this here Bob Vila stuff then I do. You guys do have me thinking about a strait edge type device that would locate on the end of the plywood as well as the parting line from which you might be able to take a center-to-center measurement. If this is a bravo sierra idea let me know.
-----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Cy Selfridge Sent: Tuesday, July 31, 2007 11:52 AM To: [email protected] Subject: RE: [BlindHandyMan] Levels and chocklines Remember one thing, don't make it square, make it fit the house. I think the same thing might apply to your ledger board. (LOL) A 24 foot board might present some logistical challenges. One trick I might try is to place something on the wall at the point you want the bottom of the ledger to be. Place this it the center point so the 24 foot board could rest on it. Now, having done this you could place a 4 foot level on top of the ledger and manipulate it until it is level then secure the board to the wall. The only way I know to be sure the uprights are perpendicular is by the use of a level. It is going to take more than one person to make this an easy task. I don't think the brew will be a lot of help on this one. (LOL) To get the tops all level you will have to check the level of the floor and calculate how much to cut off each to compensate for the difference. If all else fails there is always the good old shim. (LOL) Now, for a chalk line substitute I use a 1x2. Place a nail or screw at the ends and put to 1x2 up against these screws/nails. String or wire is (at least to me) a problem as the string will give and your line will wander a bit. If all else fails have your wife mark and set the screws/nails on the plywood that way you can blame her if they don't hit the stringers. (LOL) Cy, the Ancient Okie... _____ From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Larry Stansifer Sent: Tuesday, July 31, 2007 12:21 PM To: [email protected] Subject: [BlindHandyMan] Levels and chocklines Hi guys, Well here is a couple more pre-build questions. How do I go about leveling a 24 foot run of ledger board? What do I substitute for a snapped chock line to locate centers under the plywood? What is the most accurate way to make certain that my support poles are perfectly strait and the tops are level? I have some experience with a plumb line and it worked out ok however, I was hoping for something better. Regards Larry Stansifer Thou art rewarded for thy results not for thine efforts. The Rogue Warrior [Non-text portions of this message have been removed] No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.476 / Virus Database: 269.11.0/927 - Release Date: 7/30/2007 5:02 PM No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.476 / Virus Database: 269.11.0/927 - Release Date: 7/30/2007 5:02 PM [Non-text portions of this message have been removed] To listen to the show archives go to link http://acbradio.org/handyman.html or ftp://ftp.acbradio.org/acbradio-archives/handyman/ The Pod Cast address for the Blind Handy Man Show is. http://www.acbradio.org/news/xml/podcast.php?pgm=saturday Visit The Blind Handy Man Files Page To Review Contributions >From Various List Members At The Following address: http://www.jaws-users.com/handyman/ Visit the archives page at the following address http://www.mail-archive.com/[email protected]/ If you would like to join the Blind Computing list, then visit the following address for more information: http://jaws-users.com/mailman/listinfo/blind-computing_jaws- users.com For a complete list of email commands pertaining to the Blind Handy Man list just send a blank message to: [EMAIL PROTECTED] Yahoo! Groups Links -- BEGIN-ANTISPAM-VOTING-LINKS ------------------------------------------------------ Teach Infowest Spam Trap if this mail (ID 112828564) is spam: Spam: https://spamtrap.infowest.com/canit/b.php?i=112828564&m=28d3 329946fd&c=s Not spam: https://spamtrap.infowest.com/canit/b.php?i=112828564&m=28d3 329946fd&c=n Forget vote: https://spamtrap.infowest.com/canit/b.php?i=112828564&m=28d3 329946fd&c=f ------------------------------------------------------ END-ANTISPAM-VOTING-LINKS
