On the lever that the chain attaches to at the top, is there more than one hole that you could fasten the chain to. You might want to try to hook the chain further in or further out on the lever. I really dont know if that is even possible but is worth looking at.
Good luck -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] Behalf Of Chanting Monks Sent: Monday, September 17, 2007 11:02 PM To: [email protected] Subject: [BlindHandyMan] Toilet troubles Hi guys, Last week I had to replace the guts inside the tank. The rubber flap at the tank base, the chain and lever attached to the exterior flush handle, etc. With all new guts in the tank, when I flush, if I just push down the lever and let go instantly, the toilet starts to flush, then stops. If I hold down the lever for three to five seconds, then it works fine. I tried shortening the chain linking lever to flapper, hasn't helped. Leaving a little more play in the chain. Hasn't helped. It used to be just push the lever, toilet flushed fine, but now I can't figure out what might be adjustable that I could tinker with to get it to flush with just the old press and let go action. Any suggestions? I believe I opened the valve out of the wall to the tank right back to where it used to be, and it seems the tank is just as full as it always was, so it is just the issue of needing to hold down the handle that is bugging me. Any suggestions would be greatly appreciated. Best, Joe Monks Chanting Monks Press [Non-text portions of this message have been removed]
