Hi Ron, Thank you for the information. Have a good night. Roger C Bachelder 3rd [EMAIL PROTECTED]
_____ From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Ron Yearns Sent: Thursday, December 06, 2007 5:12 PM To: [email protected] Subject: Re: [BlindHandyMan] heating question Of course. One you can use what is called line theromstat running the power for the baseboard unit throug the stat like a light switch to control the heater. The heater would be left on the high setting or the control would be by passed. Another way is using low voltage thermostats, a transformer and control relays or contactors inserted in the power line for each room heater. The relay might be installed in the heater, a junction box or sometimes in the panel box, space permitting. The heaters would again be turned to high setting or jumpered for continous running. A lot of how to do the job would depend on the local conditions such as is the basement accessable from underneath. Is each heater on its own circuit and is the attic accessable for wiring. Many things to check out before committing on a course. And the cost consideration also Ron ----- Original Message ----- From: Roger Bachelder To: blindhandyman@ <mailto:blindhandyman%40yahoogroups.com> yahoogroups.com Sent: Thursday, December 06, 2007 8:57 AM Subject: [BlindHandyMan] heating question Hi Guys, Is there a way to convert my base board heaters, in which has a knob that consists of Low, medium, and High. to a thermostat in each room? Roger C Bachelder 3rd [EMAIL PROTECTED] <mailto:Bachelder3%40verizon.net> net [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
