Good idea. ----- Original Message ----- From: RJ To: [email protected] Sent: Sunday, December 16, 2007 9:45 AM Subject: Re: [BlindHandyMan] Drift cutters
Bob, Not being sure of what I am doing, I decided to wait until Monday and call Snow Blowers direct and have them instruct me on how to install them. After feeling around the blower, my guess is they mount on the sides of the blower and stick out like a set of horns, breaking up the drift. But that is just a guess. RJ ----- Original Message ----- From: Bob Kennedy To: [email protected] Sent: Sunday, December 16, 2007 07:51 Subject: Re: [BlindHandyMan] Drift cutters This sounds like a new idea from when I had to put them together. Hold 1 of the bars up to the shroud for the auger. The length should match either the height on the sides or the width across the front. I'm guessing they would go across the front to keep you from climbing a drift like I was talking about before. It sounds like it would cut into a drift and almost force the front to stay on the ground from the snow passing over the blade. Remember I haven't seen this before so I'm guessing here. But see if they aren't the size of the opening and then it will be easier to find where they should mount. If all else fails, call the place where you bought it. ----- Original Message ----- From: RJ To: Handyman Sent: Saturday, December 15, 2007 8:06 PM Subject: [BlindHandyMan] Drift cutters I have a package that came with the snowblower that are called slice bar kit or drift cutters. I believe these bars are to be mounted on the side of the snowblower, but not sure. Can anyone shed some light on the subject? These two bars are about 18 inches long and have several holes in them, about 1 1/4 inches wide and have 4 mounting bolts with thumb screw nuts. RJ [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
