Again!google is your friend.

tools
List of 2 items
F. Table saw or similar
G. Drill
list end

materials

A. Wooden 2×4, 15.5" long
B. (4) 3/8" wing nuts
C. (4) 3/8" ID flat washers
D. (4) 3/8" x 4" carriage bolts
E. (2) Wooden poles, 8'x1.5"x1.5"


how-to
Cut the 2×4 at a 45° angle, forming two congruent trapezoids. The parallel 
sides should measure 6 inches and 9.5 inches. These two pieces will be the 
footholds.
On the short side of the footholds, bore two holes 1.5" deep with a 3/4" wing 
bit. These holes should be spaced 4 inches apart (center to center). They
will allow the carriage bolts to extend through far enough to get the wing nuts 
on.
With a 3/8" bit, finish drilling the holes all of the way through. The 
footholds are now finished.
You need to drill eight 3/8" holes in both of the 8' poles. Start 6" from the 
bottom and drill a hole every 4" until you are 34" from the bottom.
Place the footholds at whatever height you want (start low), insert the bolts, 
and tighten on the wing nuts with the washers underneath.
To get onto the stilts, either back yourself up against a wall and step up as 
the stilts lean against the wall or have a trusted, strong friend hold them
for you. Beginners often want to hold the poles in front of them, but is is 
impossible to balance that way. You have to place the poles placed behind your
arm pits and wrap your arms around the front of them.
If you notice that the bottom of the stilts start to splinter as you use them, 
wrap some electrical or duct tape around the bottoms to slow the process.

  ----- Original Message ----- 
  From: Matt 
  To: [email protected] 
  Sent: Monday, March 03, 2008 9:48 PM
  Subject: [BlindHandyMan] Adjustible stilts


  Hello,
  Does anyone know how you go about building adjustible stilts for kids or for 
fun?
  Someone had some when I was younger, but I never looked at them, so I don't 
know how they achieved the adjustible aspect.
  It just always sounded neat.
  Just wondered if there were any discriptive plans out there.

  Matt

  [Non-text portions of this message have been removed]



   


------------------------------------------------------------------------------


  No virus found in this incoming message.
  Checked by AVG Free Edition. 
  Version: 7.5.516 / Virus Database: 269.21.3/1308 - Release Date: 3/3/2008 
10:01 AM


[Non-text portions of this message have been removed]

Reply via email to