I'll need to check the pole. I'll take a look in the archives too just in case. ----- Original Message ----- From: Tom Fowle To: blindhandyman@yahoogroups.com Sent: Friday, May 23, 2008 11:28 AM Subject: Re: [BlindHandyMan] cutting a circular hole
robert, Depends on the diameter, if its under 2 inches or so, then yoou can get cheap hole saw sets that fit a portable drill. Depending on the thickness you may have to go in from either side to get all the way through. If it's bigger than 2 inches or so, you might do it with a very heavy jig saw and a circle cutting guide. I think there are posts in the archives about this. Tom [Non-text portions of this message have been removed]
