As with most anything, you get what you pay for. If you spend any time looking at web sites selling tools, you'll notice a couple names always pop up with their router bits on sale for $5. Ever wonder why there are so many of the same brand selling everywhere for $5?
I just bought a set of the new adjustable profile bits from Freud today. I enjoy making flat and raised panel doors. I know I could have gotten something similar for $65 or so, but similar only goes as far as the shape. I've used Freud router bits and saw blades for years and haven't found many other companies that are as good or do anywhere near the quality of cut. I'm sure everyone has a favorite, but I'm betting no one will have a discount bit as a favorite. ----- Original Message ----- From: Dave Andrus To: [email protected] Sent: Saturday, March 27, 2010 4:35 PM Subject: RE: [BlindHandyMan] Router bit life Hi, I agree with terry. I now buy the more expensive, usually carbide tipped. This is especially true if you are using it on hard woods. Dave A. Working together, sharing the light of salvation seen through the cross of Jesus Rev. Dave Andrus, Director Lutheran Blind Mission 888 215 2455 HTTP://WWW.BLINDMISSION.ORG -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Terry Klarich Sent: Friday, March 26, 2010 8:18 PM To: [email protected] Subject: Re: [BlindHandyMan] Router bit life The most important factor is the quality of the bit. I have decided, I will always purchase the higher quality bits rather than going cheap. Never purchase high speed steel. These bits dull quickly and leave burn marks on the wood. Mainly, the carbide bits appear to get dull if they are coated in pitch. The best advice I have is clean them before you put them away. Also, keep them from knocking into eachother or other hard surface. The cutting edge can chip some what easily. I have heard of folks sharpening their bits with a diamond file; but, have never done it. I do know the bit is usually sharpened from the back flat side. That's my $0.02. Terry On Fri, 26 Mar 2010 18:21:38 -0400you write: > >Since using routers in my remodeled workshop is fairly new to me, I >have a question. Can router bits be sharpened as can drill bits or does >one simply discard them when dull, etc. Approximately what type usable >life do they have? I realize part of the answer to this depends on how >much one uses it. For example, today I put an edge on 3 sides of 4 1 by >12's I had made some shelves out of. Using this as an example, any idea >how many shelves I could do like this before the bit needed to be >replaced? > >thanks >Al [Non-text portions of this message have been removed]
