I just changed my outside water faucets a few months back. Their made of some kind of plastic now and they just glue in place onto Pex pipe. The job took about 5 minutes. We have PVC pipe to the outside faucets. I used a hacksaw to cut off the old brass ones, cleaned up the end of the pipe and then found my plastic pipe cutter so the other one went even quicker.
HTH Alan Please click on: http://www.home.earthlink.net/~alanandsuzanne/ There, you'll find files of my arrangements and performances played on the Yamaha Tyros keyboard. I often add files so check back regularly! The albums in Technics format formerly on my website are still available upon request. ----- Original Message ----- From: "Alan & Terrie Robbins" <[email protected]> To: <[email protected]> Sent: Thursday, July 29, 2010 9:52 AM Subject: RE: [BlindHandyMan] Outside water faucet > RJ, > > Thanks. So to make sure I understand this here is my current and proposed > situation. > > I have an old faucet mounded on the bottom row of siding on the outside of > my house. It is threaded on to a standard fitting that was soldered to > standard half inch copper pipe. Fortunately, there is a shut off in the > basement for this run. I want to relocate this to the back side of the > house as we are getting new siding put on and I want to extend the deck in > conjunction with this project. Of course you can guess that the water > outlet > is right where the deck board will bo against the house. Anyway, if I > understand you correctly above I can simply get a new faucet, length of > Pex, > and a shark bite fitting? In your case, did the faucet come pre connected > to > the length of Pex or does it simply slide on?-----Original Message----- > > thanks, > Al > > From: [email protected] > [mailto:[email protected]]on > Behalf Of RJ > Sent: Thursday, July 29, 2010 11:52 AM > To: [email protected] > Subject: Re: [BlindHandyMan] Outside water faucet > > > > I used pex pipe and shark fittings. The pipe is flexible and the fittings > just slide on. The fittings will work on Pesx, PVC, or copper pipes and > the > great part is no cleaner, glue, solder and easy to slide off with a pair > of > pliers or a tool that cost less than a buck. The pipe and fittings are > rated > at 200 P S I > ----- Original Message ----- > From: Alan & Terrie Robbins > To: Blindhandyman > Sent: Wednesday, July 28, 2010 7:39 PM > Subject: [BlindHandyMan] Outside water faucet > > I think I remember a while ago RJ put an outside faucet in > and used some type easy connector to do it? Could whoever > did this, and again, I think it was RJ, describe what you > purchased to do the job? > > thanks > Al > > [Non-text portions of this message have been removed] > > > > > > > [Non-text portions of this message have been removed] > > > > ------------------------------------ > > Send any questions regarding list management to: > [email protected] > To listen to the show archives go to link > http://www.acbradio.org/pweb/index.php?module=pagemaster&PAGE_user_op=view_page&PAGE_id=33&MMN_position=47:29 > Or > ftp://ftp.acbradio.org/acbradio-archives/handyman/ > > The Pod Cast address for the Blind Handy Man Show is. > http://www.acbradio.org/news/xml/podcast.php?pgm=saturday > > Visit the archives page at the following address > http://www.mail-archive.com/[email protected]/ > > For a complete list of email commands pertaining to the Blind Handy Man > list just send a blank message to: > [email protected]! Groups Links > > > >
