On Fri, 10 Jul 2015, Joe Touch wrote:
Can you explain where the info on using the sysupgrade command to revert
to the factory image is??
http://wiki.openwrt.org/toh/linksys/wrt1200ac#how_to_flash_the_firmware_to_device
The web ui uses the "sysupgrade" command. So implicitly the instructions
above to use "web ui" to upgrade, means you can use sysupgrade.
http://wiki.openwrt.org/doc/howto/generic.sysupgrade
So I just did:
cd /tmp
wget <url to Linksys factory image I wanted to install>
sysupgrade <filename>
Then it rebooted. I then had to use the factory default button on the
device to reset the configuration before things started working properly.
"sysupgrade -n <filename>" does this as well, but I am not sure the
Linksys configuration data is stored in the same place so that might or
might not help.
--
Mikael Abrahamsson email: [email protected]
_______________________________________________
Bloat mailing list
[email protected]
https://lists.bufferbloat.net/listinfo/bloat
