Hello Everyone,

 

I have a fault with this eppendorf centrifuge 5804 with lid lock issue.
When trying to close the top lid, the motor tries to latch the lid but
stops half way. After few tries it does close, but fails to open the lid
when button is pressed. I have replaced the lid lock motor and the lid
micro switches but fault remains. I have monitored the motor voltage.
The motor works without load, but voltage cuts off as soon as load is
applied to it.

any suggestions on what might be causing the motor voltage to cut off?? 

also link to service manual would be helpful.

 

thanks

Sarwan Mudaliar

Biomedical Engineering Technician
Goulburn Valley Health |  Graham Street  |  

SHEPPARTON  VIC 3630

Tel: 03 58323127 |  Mob: 0429 910690

Email: sarwan.mudal...@gvhealth.org.au 

http:/www.gvhealth.org.au <http://www.gvhealth.org.au> 

 

This communication is intended only to be read or used by the addressee. The 
information contained in this communication may be confidential information. If 
you are not the intended recipient, any use, interference with, distribution, 
disclosure or copying of this material is unauthorised and prohibited. The 
confidentiality attached to this communication is not waived or lost by reason 
of the mistaken delivery to you. If you have received this communication in 
error, please destroy it and notify the sender by return email.
_______________________________________________
bmelist mailing list
bmelist@bme.asn.au
http://lists.bme.asn.au/mailman/listinfo/bmelist

Reply via email to