I moved the vnqt6.1 manual in txt format from my cd to my cf card so I could read it with my voicenote. I used the find command searching forward to find references to the battery on the search word battery. I find a reference and press Read-G to start reading at that point and get reading letter by letter again as in that message I discussed from Rhonda on block commands. it says newline tab nine indent and then one character, newline tab nine indent and the next letter and so on. For several of the references I found it worked just fine, and I can't find anything that would trigger this behavior in the nature of the selections where it started reading character by character. Has anyone else ever seen this behavior? I talked to tech support, but Sam had no idea what it was doing and thinking it was my email database suggested I delete that and sart again there. Obviously that's not the problem since it also happens in a file from the cf card being read as a book.
And while I'm asking about odd behavior, I thought switching tasks allowed you to remain in the task you left except in email. When I switched from bookread to email to write this message, then put this message in drafts and went back to book read to check on exactly what was being said letter by letter, I had to reload the manual and start reading again. Is that proper? Did I misunderstand the task switching in that case? I bought my unit used in May, but it had just been given a clean bill of health and a new battery by Humanware days before I got it, so should be just fine. Are these problems or just quirks of keysoft?
