This is Joseph. I have a Classic unit myself.
According to the mPower manual, you should follow this
procedure:
1. Connect the AC adapter. The AC adapter on message
is displayed.
2. Go to Options Menu (SPACE with O) then press SPACE
with I to get into support information mode.
3. Press the letter r for recalibrate. The mPower
will initiate the charging and discharging cycle from
now on.
note: if you haven't connected the adapter already,
mPower will pop up and say that you should connect the
adapter.
4. What mPower does next depends on if the unit is
partially or fully charged. Once the battery is fully
charged. mPower will disconnect the current that is
connected to the battery compartment and will start
the discharging process. Once the battery goes flat,
it'll reconnect the current and will initiate the
charge.
5. After about 10 to 12 hours, mPower will pop up and
say that the battery test is completed. Note: you
should put your unit in a safe place near the wall
outlet. The adapter must be connected at all times.
For further information about the battery and how to
recalibrate it, refer to Chapter 2 of the mPower User
Guide under the heading "Recalibrating the battery." I
hope this information may help you.
p.s. Please note that the battery life might be
shorter on these units because it uses faster
processors. The battery might last about 18 to 20
hours on mPower versus 20 to 21 hours on a typical
Classic unit.
__________________________________
Start your day with Yahoo! - Make it your home page!
http://www.yahoo.com/r/hs
