Stacey,
Yes, after you recharge your unit, the cycle count will continue to
increase. I do not see any reason for wanting to reset this; it's like
trying to reset the milage count on a car--it is meant to monitor how far
you have gone or how many charges have you done as of current. In the
situation of a car you would get a tune up every 15,000 miles or so, the
same applies for the BrailleNote, and both units have a limit that is
reasonable and meant to notify you to get a new car or a new battery. Once
the battery counts nears 300, you should look into getting a replacement for
your battery--its life will be up soon.
Hope this makes sense.
Kevin
----- Original Message -----
From: "Stacey Robinson" <[EMAIL PROTECTED]>
To: "Braillenote list" <[email protected]>
Sent: Friday, April 28, 2006 5:51 PM
Subject: [Braillenote] Clearing the battery cycle back to one on the mpower
Hi all,
My battery cycle is at 41. I'd like to be able to clear the cycle back to
one. CAn this be done?If it can't be, could there be a way in afuture
release of keysoft so that it could be?
On the classic this would happen when the battery was recalibrated. I
have not had to recalibrate my battery yet because for the most part I run
my battery flat.
If you plug your unit in each night then unplug it during the day, would
the cycle go up each time you plugged it in?
Mine does this.
Any insight from humanware staff isgreatly appreciated.
Stacey
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
